Model of a 30-Pounder Carronade on a Carriage and Slide, Model of a 30-pound carronade on the spout on the ship's part, incomplete. The barrel is 34.5 cm long and has a caliber of 37 mm, it is equipped with a refraction ring, a feather screw through the flat grape with rain cap, a visor on the taping tape and an experimental percussion lock with a hammered-out hammer to prevent the flame from falling back from the sun hole. The horse consists of two narrow cheeks, connected by a calf in the middle, the rear axle body and the front axle, which is also the tapas. A third axle is provided for the front axle, to which is attached the knit chain, a kind of breaking chain, which on the other hand is attached to the spindle bolt in the gate threshold. The rear axle body has a slot for the eleven screw, this can be increased with a block also with slot. The carriage is a frame consisting of two wooden shelves connected by front and rear brass cross members, the front crossbar has an eye for the spindle bolt, the rear supports for the baking iron. With the front, the carriage rests on a platform on the inside of the gate threshold. The rolled horse is slanted through the carriage, i.e. with the front wheels running over the supports of the carriage, with the rear wheels underneath and thus supporting the rear of the carriage. The bakstalies are attached to the rear axle. The carriage has an additional ash body for transport, which can be placed under the carriage at the front, a beam, triangular in section, is placed on deck behind the carriage as a brake for the molecule. The entire design was focused on receiving the recule. The model is placed on a deck with a gun gate with a fall gate with a round hole for the trumpet, as accessories are added two powder horns, a pestle / wiper, a scratcher / loading scoop and a pipe bag. Scale 1: 5 (Obreen)., Rijkswerf Vlissingen, Flushing, 1835 and/or 1839, wood (plant material), brass (alloy), iron (metal), rope, leather, wool, model:

Keywords: